Featured Systems
-
Specifications
-
Drawings
-
Sizing Assistance
-
Trial / Rental Units
-
Custom Designs
888-200-1800
The Tempest Series of liquid polymer feed and control stations
are designed to provide maximized polymer performance without
the hassles and headaches these applications cause for
water treatment professionals.
The system design provides the right type of mixing energy at
the critical moment of initial wetting and tapers that energy
through a multi-stage regime of hydrating zones. The net result is
a fully hydrated polymer solution with maximum charge site exposure
which assures optimized polymer usage and performance. The design
eliminates unwanted agglomerations, plugging and the costly mess of
dealing with these issues.
The unit operation is simple. The user enters the desired
polymer concentration and selects manual or automatic
operation.
Primary dilution water flow is controlled by a solenoid valve
which allows water to enter the unit. Primary dilution water flow
rate data is measured continuously to assure that adequate flow is
present and fed back to the Tempest controller. Using calculations
derived from the calibration stage, the unit automatically adjusts
the polymer pump output to achieve the desired concentration.
Under conditions of high or low concentration, a loss of water
flow or polymer feed (optional) the system automatically shuts down
and notifies with an alarm. Each feed cycle is followed by an
adjustable, multi-stage flush cycle to eliminate any plugging . The
system can be operated remote via a 4-40mA or simple on/off
signal.
In addition to the new Tempest, EquipSolutions offers a broad
range of polymer feed equipment. These systems have been proven to
be the most cost efficient, high performance design available
today. If you need a reliable, low maintenance, economical,
high performance liquid polymer activation system that is simple to
operate....we can help.
If you require more complex or
customized designs....we can help. Liquid or Dry...we can help.